Replacement Of The Lighting - Novy Flat'line 7600 Mode D'emploi

Replacement indicator monobloc recirculation fi lter

Indication: red indicator light stays on
After a set time a red indicator light on the appliance shows
that the monobloc fi lter must be replaced.
Reset the cleaning indicator

The motor must be on. When you fi t the new
monobloc fi lters, it is suffi cient to press the
and keys for 5 seconds at the same time to
3
reset replacement indication.

You can obtain a new monobloc fi lter from
a dealer or the Novy website. Article number
monobloc fi lter: 7600060.

3.4 Replacement of the lighting

Make sure there is no power on the hood and the lighting
has suffi ciently cooled.
Open the bottom plate
Undo the screws and slide the cover off.
Removing the LED light
A. First disconnect the cable that runs to the LED to be
replaced. Disconnect by loosening the lock by exerting
slight pressure while pulling loose.
B. Remove the LED to be replaced with a gentle rotating
movement to the left.
2
Fitting the new LED light
A. Fit the new LED light in the bayonet ring
B. Make a rotating movement to the right until the LED
light is tight
C. Fasten the power cable. Put the cover back and tighten
the screws. Close the bottom plate.
3.5 Faults
If there is a fault you can contact your (kitchen) supplier
and/or Novy Customer Service.
Belgium
France
Germany
The Netherlands Tel.: +31 (0)88 011 91 10
Unite Kingdom
For all other countries: your local installer or
Novy in Belgium: +32 (0)56 36 51 02
To be able to deal with the fault promptly and effi ciently it
is necessary that the Repaired Service knows which type
of appliance you have.

You can fi nd the type number on a sticker in
the inside of the extractor hood. This becomes
visible as soon as you take the fi lter out of the
extractor hood.
You can note the type number here:
– 32 –
Tel.: +32 (0)56 36 51 02
Tel.: +33 (0)3 20 94 06 62
Tel.: +46 (0)511 54 20 771
Tel.: +44 (0) 207 866 2493