Astralpool Mini 32380 / 36651 Manuel D'installation page 5

Automatic colour sequence: Selection from among seven programmes of colour sequences. Each programme is defined by
the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE
Each press of the pushbutton changes a colour or sequence. The cycle of colours and sequences is rotary. For example, if
you are in colour 6, by pressing once you will go to colour 7. If you press once again, you will go to sequence 1. If you are
in sequence 7, press once and you will go to colour 2 which is Red.
Colour 1 is white and is reached by one long press.
6.2. Control by means of the Colorplus Series
The Mini LED spotlight can be used together with spotlights of the 27 LED Colorplus series, whatever its configuration may
be (TOP-ECO).
6.2.1. Colorplus ECO: pushbutton control
The same functions as the power supply control. For further information see section 6.1.2.
6.2.2. Colorplus TOP: control by means of Receiver
The Remote Control – Receiver – Transformer – Led Projector unit enables you to create different lighting scenarios inside
the pool with two function modes:
Fixed colour: Selection of a fixed colour among twelve possibilities.
Automatic colour sequence: Selection from among eight programmes of colour sequences. Each programme is defined by
the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE
1 Red Green
2 Cyan Purple
Emerald
3
Green
green
4 Red Orange
5 Red Magenta
6 Red Orange
Pale
7 Purple
Violet
8
Red Green
6.2.3. Electrical connection diagram
In both TOP and ECO configurations, two cables should be connected in the two 12VCA terminals of the power supply in
parallel with any spotlight (12 V Mains), as if it were another Colorplus spotlight.
The power supply will therefore interpret the signal received and will perform the same functions as the Colorplus
spotlights.
To control the projectors with a modulator receiver and/or remote control, connect the synchronism cable from the output of
a 12V transformer to the power supply. The 12V of the transformer itself can feed large projectors (if there are any), or the
12V of a 50W transformer or more, in cases of installations with Mini projectors only.
1 Red Blue
2 Red Green
3 Purple Cyan
4 Red Blue
5 Purple Cyan
6 Yellow Purple
7 Green Red
1 Red
2 Green
3 Blue
4 Yellow
5 Cyan
6 Purple
Blue
Yellow
Cyan Sky-blue Blue
Green Orange
Blue Magenta
Green Cyan Blue
Cyan Yellow White
Blue Yellow Cyan
ORDER OF COLOURS
Green Purple
Cyan Blue Purple
Yellow -
Green -
Yellow -
Cyan -
Blue -
7 Sky-blue
8 Pale Violet
9 Orange
10 Magenta
11 Emerald green
12 White
Emerald
Sky-blue Cyan
green
Magenta
Yellow Cyan Purple
Pale
Purple Sky-blue
Violet
5
Cyan Yellow
Yellow
- -
- -
- -
- -
- -
Orange Magenta
Emerald
White
green