First Use From New - Num'axes CANICOM 200 Guide D'utilisation

First use from new

Fitting the battery in the receiver collar
- Unscrew the 4 screws of the top of CANICOM using a screwdriver.
- Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery
housing (ref. Diagram 4).
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing.
Check the polarity before trying again
- Before putting the lid back in place, check that the rubber seal is in its groove.
- Screw up the 4 screws with care (do not overtighten them).
Polarity « - » of the battery
Activate/deactivate the remote control
Remote control is supplied with battery fitted.
- Activate: press for 1 second the On/Off red button ( ) located on the side of the remote control (ref.
Diagram.1). Indications appear on the LCD screen.
- Deactivate: press for 1 second the On/Off red button ( ) of the remote control (ref. Diagram.1). The
LCD screen is off.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using your CANICOM 200 for a long period.
Gb - 22
Diagram 4
Polarity « + » of the battery
( (
( (
Seal