OmniPod CAT45E Guide De L'utilisateur page 155

Appendix
Figure A-2
When your PDM alerts you that battery power is getting
low, the PDM will maximize remaining battery life by:
• Turning off your vibration alert (if set)
• Disabling bright mode
• Disabling the test strip port light
Once the batteries are replaced, these functions resume.
142
Figure A-3
If the batteries run out, data in the memory is at risk.
DO NOT remove the old batteries until you have new
ones at hand. The PDM protects data in the memory
for up to 2 hours after the batteries run out or are
removed.
To replace batteries
1. Open the battery compartment on the back of the PDM by
pushing the compartment latch inward and then upward
(Figure A-3). No special tools are necessary.
2. Insert 2 new AAA alkaline batteries into the compartment.
The diagram inside the compartment shows you
which direction to insert the batteries.
3. Replace the battery door.
4. Turn the PDM face up. The PDM powers on automatically.
The PDM is now ready to use. Dispose of the old batteries in
accordance with local waste disposal regulations.