Manual Shut-Off Of A Hazard Alarm - OmniPod CAT45E Guide De L'utilisateur

10
Alerts and Alarms
Alarm
Pod deactivation required.
Press "Ok" to deactivate.

Manual Shut-off of a Hazard Alarm

n
If you respond to a hazard alarm but the PDM cannot
communicate with the Pod to acknowledge or shut off the alarm,
you can shut off the alarm manually.
1. Remove the Pod from your body if you have not already
done so.
2. Press the end of a paper clip or similar item straight down into
the manual alarm shut-off port (Figure 10-2) on the bottom of
the Pod. The port can be found by peeling back the adhesive
pad from the bottom of the Pod at the square end. The alarm
shut-off port is to the right of the fill port.
3. Press the paper clip straight down into the manual alarm shut
off port until the alarm stops and can no longer be heard.
Then discard the Pod according to local waste disposal
regulations.
132
Type Source Beep Pattern
Hazard PDM Continuous tone.
Alarm
Action
This alarm occurs after a PDM error
occurs that requires the user to reset the
date and time. Press OK to
acknowledge.
Change Pod.
Check blood glucose.
4. Hard Reset port is located in the PDM's battery compartment
(Figure 10-3). The "Hard Reset" allows the user to reset the
PDM (i.e. if the screen locks up and goes into an alarm). The
users PDM settings are not lost.
Figure 10-2
Manual
alarm
shut-off
port
Fill
port
Figure 10-3
Hard
Reset