Publicité
Les langues disponibles
Les langues disponibles
BLUETOOTH AUDIO
Please follow the pairing instructions below to link the unit to your Bluetooth device.
1. Press the SOURCE button repeatedly to enter the Bluetooth mode. The display will show "BT". It will start searching
and will keep flashing.
2. If the unit has never been paired with a Bluetooth device before or cannot find the last paired device, the display and
the Bluetooth status indicator will keep on flashing. Turn on the Bluetooth function of your device and enable the
search until "Lenco SCD-685" is found. Select "Lenco SCD-685" on the Bluetooth device to make connection. Enter
the pass code "0000" if required.
3. After successfully paired the unit will display steady "BT" without flashing.
4. You can now start playing music from your smartphone wirelessly to the speaker.
5. You can press the
6. You can press the PREVIOUS
Press the PAIR button on the remote control (or press and hold the PAIR button on the unit) will disconnect the
current connection and start to search another new Bluetooth device
AUX IN
This allows you to connect an external player's sound through your unit.
1. Plug a 3.5mm audio cable (not included) into your external player's line out and the other end into the AUX jack.
2. Press the SOURCE button to enter AUX mode. Display shows "AUX"
3. Start your external player to play music.
4. The unit will output the sound.
ENERGY SAVING
Due to ErP stage 2 requirement and protect the environment, the unit will turn off to the standby mode automatically once
no music has been playing around 15 minutes.
To reactivate the unit, press the STANDBY button to turn on the unit.
CLOCK SETUP
You can set the clock.
1. Turn off the unit to Standby mode.
2. Press and hold the MENU button, it will show the time display format.
3. Press the
TUNE- or
to continue.
4. The Hour digits will flash. Press the
continue.
5. The Minute digits will flash. Press the
button to complete the setup.
The clock setting may automatically be overridden by the DAB or FM station broadcast real time information.
SOFTWARE VERSION CHECK
You can check the unit software version.
1. Turn on the unit in DAB mode or FM mode.
2. Press the MENU button to access the menu control.
3. Press the
TUNE- or
software version number.
4. Press the MENU button to exit the menu control.
LANGUAGE SETUP
You can set the unit's language.
1. Turn on the unit in DAB mode or FM mode.
2. Press the MENU button to access the menu control.
3. Press the
TUNE- or
4. Press the
TUNE- or
press the ENTER button to confirm.
5. Press the MENU button to exit the menu control.
FACTORY RESET
This function resets the unit to the original factory settings.
1. Turn on the unit in DAB mode or FM mode.
2. Press the MENU button to access the menu control.
3. Press the
TUNE- or
4. Press the
TUNE- or
button to pause or resume the playback.
or NEXT
TUNE+ button to toggle between 24Hour or 12 Hour display format. Press the MENU button
TUNE- or
TUNE- or
TUNE+ button until "SW Version" is displayed and then press the ENTER button to show the
TUNE+ button until "Language" is displayed and then press the ENTER button.
TUNE+ button to toggle between different languages. Select your desired language and then
TUNE+ button until "Factory Reset" is displayed and then press the ENTER button.
TUNE+ button until "<Yes>" is displayed and then press the ENTER button to reset the unit.
button to search to the previous or next song.
TUNE+ button to change the hour value. Press the MENU button to
TUNE+ button to change the minute value. Press the MENU
14
Publicité
