Sony MiniDisc Deck MDS-JA20ES Mode D'emploi page 11

When "TOC Writing" flashes in
the display
The deck is currently updating the
Table Of Contents (TOC). Do not
move the deck or pull out the AC
power cord. Changes to an MD
made through recording are saved
only when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing the
1/u switch.
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press § OPEN/CLOSE to take out the MD or
change the deck to standby by pressing 1 /u . "TOC Writing" will flash in the
display at this time.
After "TOC Writing" stops flashing and goes out, you can pull out the AC
power cord.
To Press
p
Stop recording
P. Press the button again or press ( to resume
Pause recording*
recording.
§ OPEN/CLOSE after stopping
Take out the MD
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
Rear of the disc
Basic Operations
Record-protect tab
Slide the tab in the
direction of arrow
11 EN