Maintenance - Haussmann MJ2625VIA Guide De L'utilisateur

OPERATION
CAUTION: Be sure to return the stopper arm to the original position when performing
an operation other than groove cutting.
CARRYING THE TOOL (fig. 24)
Make sure that the tool is unplugged. Secure the blade at the 0° bevel angle and
rotary table to the right mitre angle fully.
Secure the slide poles after pulling the carriage toward you fully.
Lower the handle fully and lock it in the lowered position by pushing in the stop pin.
Carry the tool by holding the base as shown in the figure. If you remove the clamp,
dust bag, etc., you can carry the tool more easily. Carry the tool by one hand holding
the carrying handle and the other hand holding tool base.
Always secure all moving portions before carrying the tool.
Stopper pin is for carrying and storage purposes only and not for any cutting
operations.

MAINTENANCE

Make sure the mitre saw is disconnected from supply before installation, before
cleaning and maintenance operations.
After use, wipe off chips and dust adhering to the tool with a cloth or the like. Keep
the blade guard clean according to the directions in the previously covered section
entitled "Blade guard". Lubricate the sliding portions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you fully.
If the supply cable is damaged, it should be replaced by the same type of
cable as the one provided and recommended by the manufacturer qualified
repairman.
ADJUSTING THE CUTTING ANGLE
This tool is carefully adjusted and aligned at the factory, but rough handing may
have affected the alignment.
If your tool is not aligned properly, perform the following:
MITRE ANGLE (fig. 25, 26 & 27)
Push the carriage toward the guide fence and tighten the locking screw to secure
the carriage. Loosen the grip which secures the rotary table.Turn the rotary table
so that the pointer points to 0
clockwise and counterclosewise to set the rotary table in the 0
Lower the handle fully and lock it in to the lowered position by pushing in the stop
pin. Square the side of the blade with the face of the guide fence using a triangular
rule, tri-square, etc. (fig 26)
Make sure that the pointer points to 0° on the mitre scale. If the pointer does not
point to 0°, loosen the screw which secures the pointer and adjust the pointer so
that it will point to 0°. (fig 27)
42
on the mitre scale. Then turn the rotary table slightly
o
fig.24
fig.25
mitre notch. (fig 25)
o
Guide fence
fig.26
fig.27
Guide fence Knob
Triangular rule
Screw
Pointer
Mitre scale