Electrical Information; Unpacking - Haussmann MJ2625VIA Guide De L'utilisateur

ELECTRICAL INFORMATION

GUIDELINES FOR USING EXTENSION CORDS
WARNING: This mitre saw is intended for indoor use only. do not expose it to rain
or use it in damp locations.
Make sure the extension cord is in good condition. When using an extension cord,
be sure to use one that is heavy enough to carry the current that your product will
draw. An undersized cord will cause a drop in line voltage, which will result in loss
of power and overheating. The table below shows the correct size to be used
according to cord length and nameplate ampere rating. When in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
Ampere Rating
More Than Not More Than
0 6
6 10
10 12
12 16
Make sure your extension cord is properly wired and in good condition. Always
replace a damaged extension cord, or have it repaired by a qualified person
before using it. Keep your extension cords away from sharp objects, excessive
heat, and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit must consist of no
less than a #12 wire with a 20 A time-delayed fuse or a #14 wire with a 15 A
time-delayed fuse. Before connecting the motor to the power line, make sure
the switch is in the OFF position and the electric current is rated the same as
the current stamped on the motor nameplate. Running at a lower voltage will
damage the motor.

UNPACKING

Refer to illustration below..
1. Carefully remove the mitre saw from the carton.
2. Separate the parts.
3. Lay out all of the parts, and check them against the parts listed below. Examine
all of the parts carefully.
Mitre saw
34
(when using 120 V only)
Total length of cord in feet (metres)
25' (7.62 m) 50' (15.24 m)
18 16
18 16
16 16
14 12
Dust bag
100' (30.5 m) 150' (45.72 m)
16 14
14 12
14 12
Not Recommended
Vertical clamp
!
Blade wrench Hex key