Troubleshooting; Warranty - Haussmann MJ2625VIA Guide De L'utilisateur

TROUBLESHOOTING

PROBLEM
Motor does not start
Angle of cut inaccurate
Cutting arm cannot fully raise,
or blade guard cannot fully
colse
Blade binds, jams or shakes
Saw vibrates or shakes
Laser line projection is hard to see

WARRANTY

Thank you for investing in a HAUSSMANN tool. These products have been made
to demanding, high-quality standards and are guaranteed for domestic use
against manufacturing faults for a period of 36 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of
your tool (failure, missing part, etc.), please contact one of our service technicians
at our toll free service line at 1-866-206-0888 from 8 AM to 6 PM, Monday to
Friday, Eastern time. RONA reserves the right to repair or replace the defective
tool, at its discretion.
The product is guaranteed for 36 months if used for normal trade purposes. Any
guarantee is invalid if the product has been overloaded or subject to neglect,
improper use or an attempted repair other than by an authorized agent.
Heavy-duty, daily professional or hire usage are not guaranteed. Due to
continuous product improvement, we reserve the right to change the product
specification without prior notice.
Register your product
We invite you to register your product online to make future communications
easier. To do so, simply visit our website www.haussmanntools.com.
46
CAUSE
Saw not plugged in
1. Mitre table unlocked
2. Too much sawdust under table
1. Parts failure
2. Pivot spring not replaced properly
after service
3. Sawdust built up
4. Saw-head locking pin not set
properly
1. Saw blade damaged
2. Dull blade
3. Improper blade
4. Warped blade
1. Saw blade damaged
2. Saw blade loosened
3. Saw not properly fastened down
4. Workpiece not properly supported
1. Light in work area is too bright
2. Saw dust on the laser lens
SUGGESTED SOLUTION
Check that all cords are plugged in
1. Use mitre table locking lever. (see
adjustment section)
2. Vacuum or blow out dust. Wear eye
protection
1. Contact service centre
2. Contact service centre
3. Clean and lubricate moving parts
4. Check, adjust and properly set
sawhead locking pin
1. See operation section
2. Replace or sharpen blade
3. Replace blade
4. Replace blade
1. Replace blade
2. Tighten arbor bolt
3. Fasten saw to stand, bench or
table
4. Properly support or clamp
workpiece
1. Move the mitre saw to the work
area with proper light
2. Clean laser lens with a soft dry
brush