Troubleshooting - Haussmann 92109B Manuel De L'utilisateur

TROUBLESHOOTING

Troubleshooting
Problem
The motor does not
run.
The motor starts
slowly and does not
reach running speed.
Excessive motor
noise.
The motor does not
reach full power.
Motor overheats
easily
Decrease in cutting
power when
The saw cut is rough
or wavy.
The work piece rips
or splinters.
EN
Possible Cause
Faulty motor, power supply cable
or plug.
Burned out fuses.
Low-power supply voltage.
Damaged windings. Burned out
capacitor.
Damaged windings. Faulty motor. Have the motor checked by
Overloaded circuit due to lighting,
utilities or other motors.
Overload of the motor; inadequate
cooling of the motor.
The saw blade is too small
(sharpened too often).
The saw blade is dull; the
tooth shape is not suited to the
thickness of the material.
The cutting pressure is excessive
or the saw blade is not suited to
the application.
Help
Have the machine checked by
skilled personnel. Do not try to
repair the machine yourselves
as it may be dangerous. Check
the fuses and replace them if
necessary.
Ask the Electricity Distributor
to check the voltage available.
Have the machine motor
checked by skilled personnel.
Have the capacitor replaced by
skilled personnel.
skilled personnel.
Do not use other utilities or
motors on the circuit to which the
cutting-off machine is connected.
Prevent overloading the motor
when cutting; remove dust from
the motor to ensure an optimum
cooling of the motor.
Re-adjust the end stop of the
saw unit.
Re-sharpen the saw blade or use
an appropriate saw blade.
Use the correct saw blade.
14