Haussmann 92109B Manuel De L'utilisateur page 11

OPERATING INSTRUCTIONS
compliance with voltage safety regulations
and that the socket is in perfect condition.
The electrical system must be fitted with a
magneto-thermal protective device to
safeguard all conductors from short circuits
and overload.
The selection of this device should be in line
with the following electrical specifications of
the machine stated on the motor.
NOTE: Your mitre saw's electrical system
is equipped with an undervoltage relay
which automatically opens the circuit
when the voltage falls below a minimum
pre-established limit and which prevents
the self-reset of machine functions when
voltage returns to normal levels.
If the machine stops involuntarily, do not be
alarmed.
Make sure that there has not been a
voltage failure in the electrical system.
ADJUSTING
ATTENTION: All the adjustment procedures
illustrated below must be performed when
the machine's engine is off.
Cross-cutting Operation:
Swiveling the Table Top (Fig. 2)
By turning the table, the undercut mitre
saw can be moved to the left- and right-
hand side. Using the scale, an exact angle
setting is possible. 15°, 22,5°, 30°, angles
from 0° to 45° can be quickly and precisely
set. For swinging the turning table, release
the locking screw (a) and turn the unit at
the handle (1) until the desired angle is
obtained. Then secure with locking screw
(a).
Tilting the Saw Unit (Fig. 3)
The saw unit can be tilted up to an angle of
45º.
Loosen the hand grip (b) on the back of the
machine and, using the scale, tilt the unit to
the desired angular position.
The angle can be determined using the
indicator (c) on the scale (a). Finally, the
hand grip must be securely re-tightened.
Operations
After having performed all the above
procedures and operations, you may begin
cutting.
Warning: Always keep hands away from
the cutting area and do not try to approach
it when the machine is running.
Cross-cutting Operation (Fig. 4)
• Release the locking button (13)
• Raise the saw unit using the hand grip
(1) until the unit locks into the uppermost
position.
• Press the work piece uniformly against
the block bars (a), while ensuring that your
hand is outside the cutting zone of the saw
blade.
• With the right hand on the hand grip (1),
so that the unit can be swiveled downward.
• After pressing of the start button (2) the
engine starts running.
• Apply the saw blade slowly to the work
piece and cut through it by applying slight
pressure.
• Swing the unit back into the starting
position until it locks into place.
• Release the hand grip (1), so that the
motor shuts off.
Changing the Saw Blade (Fig. 5)
• Pull the power plug.
• Put the sawing unit in the upper position.
• Release the movable saw blade guard (10)
and lifting the saw blade guard at the same
time to free the saw blade.
• Release the saw blade fixing screw
(Attention: left-handed thread).
• Remove bolt (a) and saw blade flange (b).
• Take off the saw blade with caution (risk of
injury through saw blade teeth).
• Place the new saw blade onto the inner
11
EN