Haussmann MJ2625VIA Guide De L'utilisateur page 38

Pointer
Lever
Arm
Bevel scale
fig.6
Slide lock knob
fig.7
Laser switch
fig.8
ASSEMBLY AND ADJUSTMENTS
ADJUSTING THE BEVEL ANGLE (fig. 6)
• When tilting the carriage to the left, loosen the lever at the rear of the tool
counterclockwise.
• Unlock the arm by pushing the handle somewhat strongly in the direction that you
intend to tilt the saw blade.
• Tilt the carriage until the pointer points to the desired angle on the bevel scale.
• Then tighten the lever clockwise firmly to secure the arm.
CAUTION: When tilting the carriage, be sure to raise the handle fully. After changing
the bevel angle, always secure the arm by tightening the lever clockwise.
SLIDE LOCK ADJUSTMENT (fig. 7)
To unlock and lock the slide fence, turn the lock knob counterclockwise or clockwise.
LASER (fig. 8)
• To turn on the laser beam, press the upper position (I) of the switch. Press the
lower position (O) to turn off.
• Laser line is factory adjusted so that it is positioned 1 mm from the side surface
of the blade (cutting position).
CAUTION: When not in use, be sure to turn off the laser. Never look into the laser
beam directly; Laser beam may injure your eyes.
LASER RADIATION: DO NOT STARE INTO THE BEAM or any CLASS II LASER
PRODUCTS.
CLEANING OF THE LENS FOR THE LASER LIGHT
If the lens for the laser light becomes dirty, or sawdust adheres to it in such a way
that the laser line is no longer easily visible, unplug the saw and clean the lens for
the laser light carefully with a damp, soft cloth. Do not use solvents or any petroleum-
based cleaners on the lens.
NOTE: When laser line is dim and almost or entirely invisible because of the direct
sunlight in the indoor or outdoor window near your work area, relocate the work
area to a place not exposed to direct sunlight.
NOTE: All of the adjustments for the operation of this machine have been carried
out at the factory.
CAUTION: Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure. The use of
optical instruments with this product will increase eye hazard. Do not attempt to
repair or disassemble the laser. If unqualified persons attempt to repair this laser
product, serious injury may result. Any repair required on this laser product should
be performed by authorized service center personnel.
ATTENTION/CAUTION
!
RAYONNEMENT LASER. NE REGARDEZ PAS
DIRECTEMENT DANS LE FAISCEAU.
LASER RADIATION. DO NOT STARE INTO BEAM.
Longueur d'onde / Wavelength: 650 nm
Puissance maximale / Max. Output: 1 mW
Produit laser de classe II
Class II Laser Product
Conforme au règlement 21 CFR sections 1040.10e
Complies with 21 CFR 1040.10e
37