Explanation Of The Buttons; Display - Unold 68125 Notice D'utilisation

strike the baking pan against a table edge or worktop.
This could cause dents in the baking pan.
16. If the kneader remains in the bread, you can pull it
out with the included hook. Insert hook at the bottom
of the warm loaf into the opening in the kneader and
allow it to catch on the bottom edge of the kneader,
preferably at the point where the blade of the kneader
is located. Now carefully pull the kneader out of the
bread. As you pull, you will see where the blade of the
kneader is located in the bread and pull it out.
17. Then clean the baking pan as described on page 39.

EXPLANATION OF THE BUTTONS

Menu
The number
displayed
indicates
the currently
selected menu.
Time selection
+
Increase of the
desired time
User program
For setting the
desired user
program

DISPLAY

BASIC SETTING:
As soon as the appliance is plugged into the electrical
outlet, and the appliance is switched on via the ON/OFF
switch, the display shows 2:40. Program 1 (Basic) is dis-
played and the light degree of browning is displayed.
During operation, the program status is indicated both by
the time countdown and the symbols on the display.
The following messages on the display indicate an error:
CAUTION:
The appliance becomes very hot!
Browning
The selected degree
of browning is indi-
cated with an arrow
in the display.
Time selection
-
Decrease of the
desired time
Start/Stop button
Starts and stops the
program
HHH or LLL: This message indicates a defect in the tem-
perature sensor. Please have the appliance inspected by
our service department.
E E0 and E E1:
If this appears after pressing the START/STOP button the
appliance is still too hot from the last baking cycle. Open
the lid and allow the appliance to cool for another 10 to
20 minutes.
Copyright UNOLD AG | www.unold.de
35