Sony VPL-SW630C Guide De Référence Rapide page 47

Installing Batteries
Remote Commander
1
Pull out the lithium battery
compartment.
Pull out the battery compartment with a
stick as shown in the illustration.
2
Insert a lithium battery.
3
Close the lithium battery
compartment.
Installing batteries
One lithium battery (CR2025) is supplied
for the RM-PJ8 Remote Commander. To
avoid risk of explosion, use a lithium battery
(CR2025).
Interactive Pen Device
1
Remove the battery cover.
The battery cover is attached to the
Interactive Pen Device by a small strap. Be
careful not to break the strap when opening
the battery cover.
2
3
Installing batteries
Four size AAA (R03) batteries are supplied
for the IFU-PN250A/IFU-PN250B
Interactive Pen Device. To avoid risk of
explosion, use size AAA (R03) manganese
or alkaline batteries.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
With the 3 (plus)
obey the law in the relative area or country.
side facing up.
Insert two size AAA batteries.
Re-attach the battery cover.
Checking the Supplied Accessories
11
GB