Adjustment Of Mechanical Disc Brakes - Wayscral ANYWAY E-200 Notice D'utilisation

● In case of rain or damp weather, braking distances are longer. It is
● If turning and braking, the handlebars can have a negative influence on the
● Do not touch the disc brakes after heavy use of your power-assisted bicycle's
1.

Adjustment of mechanical disc brakes

The pads exert a pressure on a disk attached to the hub of the wheel. The intensity of the pressure is
controlled by a brake lever with a cable. Do not operate the brake lever when the wheel is detached from
the frame or the fork.
To align the mechanical disc brake calliper, loosen the brake calliper bracket mounting screws. Brake with
the corresponding brake lever (the brake calliper is correctly positioned) and hold the brake lever in this
position while tightening the calliper bracket fixing screws.
Check that the inner pad (inside the wheel) is 0.2-0.4 mm from the disc. If this is not enough, tighten the
pad positioning screw to 0.2-0.4 mm between the pad and the disc.
To adjust the outer pad (outside the wheel), simply change the tension of the brake cable to obtain a gap
of 0.2 - 0.4 mm, at the calliper or brake lever level.
Be careful not to spray oil or lubricating material on the disc or pads (for example when servicing the chain
or derailleur). If this happens, the pads and disc should be degreased or changed.
Check the alignment of the pads by spinning the wheel, you can go on the roads
Discs: your bicycle is equipped with 160mm diameter discs.
● A system consisting of a nut and a locking nut allows you to adjust the cable tension and therefore
the braking power, which will vary with time as the brake pads wear down.
● The brake pads are standard, replace them when your pad no longer has any friction.
recommended to anticipate braking in such a situation.
cyclist's response time.
braking system as you may get burnt.
45