Cleaning Short Pile Carpets; Switching Off - Dirt Devil Spider Mode D'emploi

M607.book Seite 44 Dienstag, 18. Juni 2013 10:44 10
7 Use

7.2 Cleaning short pile carpets

ATTENTION:
Before you can use the appliance to vacuum short pile carpets you must prepare it as described
below. Otherwise the appliance would not be able to move forward on carpet. In addition, do not
use the appliance on long pile carpet. In either case the motors of the appliance could be dam-
aged due to overload.
22

7.3 Switching off

23
44
1. Ensure that the appliance is switched off
(On/Off switch in the "0" position).
2. Pull off the two round brooms (Fig. 22).
3. Now the appliance is ready to vacuum
short pile carpets. Proceed as described
under Chapter 7.1, 'Cleaning hard
floors'.
Proceed as follows to switch off the appliance:
1. Switch off the appliance with the On/Off
switch (Fig. 23) (position "0").
- The LEDs will go out.
2. If you want to stop working with the appli-
ance, empty the dust container, Chapter
8.2, 'Emptying the dust container'.
NOTE:
If you lift the appliance while it is in opera-
tion, the motors will switch off automatically
after approx. 1 second without floor contact.
However, in this case the appliance is not
switched off (blue LED remains illumi-
nated); it will start up again as soon as it is
placed on a substrate.