How To Operate; Paper Bag: Removal & Replacement; Filter Pad Cleaning Instructions - Dirt Devil M085590 Manuel Du Propriétaire

TOOL CADDY, HOSE, AND TOOL ASSEMBLY: CONTINUED
7. 8.
Push back dirt window flap. Align tabs Place the hose into the
on clear dirt passage window with the two side hose clips.
slots on the lower hose cuff. Push and
turn to lock into place (inset).

HOW TO OPERATE

WARNING: FULLY ASSEMBLE CLEANER BEFORE OPERATING.
NOTE: Paper bag must be properly installed before operating.
QUICK CORD RELEASE CORD GUIDE
2.
1.
To release your cord, turn the Keep the cord out of the way
top cord hook to the left or while you vacuum by snapping
right. it into the cord guide on the
back of the handle.
FLOOR/CARPET CLEANING
2.
1.
Release the handle. With your Move the handle and adjust it to the
foot, depress the handle desired position for (A) storing the
release pedal on the left side of upright, (B) operating the cleaner, and (C)
the base. low profile for cleaning under furniture.
NOTE: You will need to depress handle
release pedal again for low profile.
TOOL STORAGE
9.
C
ATTACH TOOLS: (A) - Slide the dust
brush onto the post on the tool caddy
with bristles facing out. Push down to
secure. (B) - Slide the extension wand into
the round slot on the right. (C) - Slide the
crevice tool into the round slot on the left.
ON/OFF SWITCH
3.
Plug cord into electrical outlet.
Step on the power switch to turn
on the cleaner. Switch is grey
and located on the base of the
unit.
ABOVE FLOOR CLEANING
1.
A
B
C
Cleaner must be locked in the
upright position to lift the
rotating brush off the carpet
when cleaning above the floor.
Turn cleaner off BEFORE
attaching or removing hose.
7
NOTE: Unplug cleaner before changing paper bag. Cleaner must have paper bag in place at all times.
BAG TYPE
For Bag Type U replacements, please call 1-800-321-1134 or visit our website at
U
www.dirtdevil.com to locate a dealer nearest you.
A
TO REMOVE
B
1.
Take front panel off by
squeezing front panel release
lever towards you.
TO INSTALL
1.
Raised
Locking Tab
Push cardboard collar past raised locking tabs on the dirt tube
with both hands (Diagram 1). The bottom of the bag should be
resting on the posts located inside the right and left of the bag
chamber (Diagram 1a). Be sure paper bag is fully extended
and tucked in at the top and bottom (Diagram 1b).
WARNING: UNPLUG CLEANER BEFORE CHANGING FILTER.
BAG CHAMBER FILTER (INTERNAL)
Located under the paper bag.
1.
PAPER BAG: REMOVAL & REPLACEMENT
2.
Raised Locking Tab
Grasp cardboard collar of paper bag
with both hands and pull past raised
locking tabs on the dirt tube. Dispose
of old paper bag.
1a. 1b.
Replace front panel by putting the one bottom
tab in the slot on the vacuum (Diagram 2). Close
until it snaps into place (Diagram 2a).

FILTER PAD CLEANING INSTRUCTIONS

2.
Take front panel off
by squeezing front
panel release lever
towards you.
8
3.
Hole
IMPORTANT: EXTEND BAG AWAY
FROM HOLE BEFORE INSTALLING.
Press in opening to clear paper
away from hole.
2. 2a.
Slot
Tab
Lift up on front edge
and pull towards you to
remove. Brush or
shake filter debris until
dirt stops falling from
the filter. In some
cases, more or less
cleaning of the filter
may be required.