Package Contents; Parts And Controls; Using The Power Bank - Beurer HK 67 Mode D'emploi

Ceinture chauffante mobile to go
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Batteries must be charged correctly prior to use. The instructions from the manufacturer and
the specifications in these instructions for use regarding correct charging must be observed at
all times.
• For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be
easily accessible.
• Never expose the power bank to extreme heat. This applies in particular to storage in a car.
Extreme temperatures can occur inside the vehicle and in the glove compartment when the
vehicle is parked for a long period of time. Therefore, remove the power bank from the vehicle.
• If you have any questions about using this device, contact Customer Service.
CAUTION
This heating belt is equipped with a Safety Shut-off Sensor that prevents the heating
belt from overheating. If the Safety Shut-off Sensor is triggered, the Power Button on the heating
belt and the white LED on the power bank remain illuminated. After cooling down, the heating
belt switches on automatically.

2. Package Contents

1 x Mobile Heating Belt To Go HK67
1 x Power Bank Type WE-213
1 x Charging Cable
1 x Storage Bag
1 x Instruction Manual

3. Parts and Controls

1. Power Bank Type WE-213
2. Heating Belt
3. Power Button
4. Power Cable
5. Charging Cable
6. Storage Bag

4. Using the Power Bank

Charge the Power Bank before initial use and if the device has not been used for a long period.
To charge:
1. Insert the provided Charging Cable into the connection socket of the Power Bank.
2. Connect the other end of the Charging Cable to a USB charger via the USB port (USB charger not included)
with at least a 1-Amp output. The Battery Level LED on the Power Bank will flash white while charging.
The charging/decharging levels are as follows:
1 x flash: 0 % - 25 %
2 x flash: 26 % - 50 %
3 x flash: 51 % - 75 %
4 x flash: 76 % - 99 %
Steady on 100 %
3. The Power Bank is fully charged when the Battery Level LED stops flashing and displays steadily (about
4.5 hours for a completely discharged Power Bank).
1
4
3
5
4
2
6

Publicité

Table des Matières
loading

Table des Matières