Makita 9556PB Manuel D'instruction page 9

The direction for mounting the lock nut and the inner
flange varies by wheel thickness.
Refer to the table below.
100 mm (4")
Abrasive cut-off wheel
Thickness: Less than 4 mm (5/32")
1
2
16 mm (5/8")
3
1. Lock nut 2. Abrasive cut-off wheel
115 mm (4 - 1/2") / 125 mm (5")
Abrasive cut-off wheel
Thickness: Less than 4 mm (5/32")
1
2
22.23 mm (7/8")
3
1. Lock nut 2. Abrasive cut-off wheel
WARNING:
• When using an abrasive cut-off / diamond
wheel, be sure to use only the special wheel
guard designed for use with cut-off wheels.
• NEVER use cut-off wheel for side grinding.
• Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an excessive
depth of cut. Overstressing the wheel increases
the loading and susceptibility to twisting or
binding of the wheel in the cut and the possibility
of kickback, wheel breakage and overheating of
the motor may occur.
• Do not start the cutting operation in the work-
piece. Let the wheel reach full speed and care-
fully enter into the cut moving the tool forward
over the workpiece surface. The wheel may
bind, walk up or kickback if the power tool is
started in the workpiece.
• During cutting operations, never change the
angle of the wheel. Placing side pressure on
the cut-off wheel (as in grinding) will cause the
wheel to crack and break, causing serious per-
sonal injury.
• A diamond wheel shall be operated perpendicu-
lar to the material being cut.
Thickness: 4 mm (5/32") or more
16 mm (5/8")
3.
Thickness: 4 mm (5/32") or more
22.23 mm (7/8")
3.
Diamond wheel
Thickness: Less than 4 mm (5/32")
1
4
20 mm (13/16")
3
Inner flange 4. Diamond wheel
Diamond wheel
Thickness: Less than 4 mm (5/32")
1
4
22.23 mm (7/8")
3
Inner flange 4. Diamond wheel
Operation with wire cup brush
(optional accessory)
1
► 1. Wire cup brush
CAUTION:
• Check operation of brush by running tool with no load,
insuring that no one is in front of or in line with brush.
• Do not use brush that is damaged, or which is out of
balance. Use of damaged brush could increase poten-
tial for injury from contact with broken brush wires.
9 ENGLISH
Thickness: 4 mm (5/32") or more
20 mm (13/16")
Thickness: 4 mm (5/32") or more
22.23 mm (7/8")