Descaling; Cleaning - Siemens TI 903 Serie Mode D'emploi

en Service programmes
Press the rotary selector to start the
3.
programme.
Empty, clean and re-connect the milk
4.
container.
Place an empty glass under the
5.
outlet system and confirm.
The programme runs.
Empty, clean and re-connect the milk
6.
container.
Empty the glass.
7.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
8.
programme.
The milk system should also be subject
to thorough manual cleaning at regular
intervals. ~ "Cleaning the milk system"
on page 51

Descaling

Duration: approx. 21 minutes
The line at the bottom of the display
indicates in how many minutes the
water tank will need to be rinsed and
refilled with water, for example.
Press the $/± button to open the
1.
menu.
Use the rotary selector to select
2.
"Descale".
Press the rotary selector to start the
3.
programme.
The instructions in the display guide you
through the programme.
Empty the drip tray and re-insert.
4.
Empty, clean and re-connect the milk
5.
container.
Remove the water filter (if present)
6.
and confirm.
Fill the empty water tank with
7.
lukewarm water up to the marking
"0.5 l". Release one descaling
tablet TZ80002 in the water.
Place a container with a capacity of
8.
at least 1.0 l under the outlet system
and confirm.
Press the rotary selector.
9.
The programme runs.
54
Duration: approx. 19 minutes
Info: If there is not enough descaling
solution in the water tank, you will be
asked to: Refill with still water and
confirm.
Rinse out the water tank and (if
10.
removed) re-insert the water filter.
Pour in fresh still water up to the
11.
"max" marking and re-insert the
water tank.
The programme runs.
Duration: approx. 2 minutes
Empty the container and confirm.
12.
Empty the drip tray and re-insert.
13.
Empty, clean and re-connect the milk
14.
container.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
15.
programme.

Cleaning

Duration: approx. 6 minutes
Press the $/± button to open the
1.
menu.
Use the rotary selector to select
2.
"Clean".
Press the rotary selector to start the
3.
programme.
The instructions in the display guide you
through the programme.
Empty the drip tray and re-insert.
4.
Open the grounds compartment,
5.
add a cleaning tablet, close the
grounds compartment and confirm.
Place a container with a capacity of
6.
at least 1.0 l under the outlet system
and confirm.
The programme runs.
Duration: approx. 5 minutes
Empty the container and confirm.
7.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
8.
programme.