Starting Up The Time Pulse Distribution - Gorgy Timing GTC-3080 Mode D'emploi

☛
When programming a wrong date or time (e.g. 30 FEVR), the menu is
exited done without modifying date and time of the time base.
☛
In synchronization input mode, the time setting is automatic upon

5.2. StaRtInG UP tHE tIME PULSE DIStRIBUtIOn

☛
The receiver clocks connected to the relevant circuit must be preset all
► Press the "menu" key repeatly
until it shows next menu:
► Confirm by pressing «EntER»:
This screen appears and the indi-
cation «nO» flashes.
► Using the «+» or «-» button, diplay
YES and confirm by «EntER» to
activate the output screen: the
tens of hour is now flashing.
► Using the "+", "-" and "EntER" buttons, set the time indicated by the clocks connected
to the circuit:
► Tens of hour
► Units of hour
► Tens of minute
► Units of minute
► Half-minute 00 or 30 seconds in the case of a half-minute circuit.
► After that, press "EntER", to validate the time and the display will go back automati-
cally to the basic screen.
MDE-Radio-Timing-GTC-3080V2.3
reception of two successives coherent time values.
at the same time.
SETTING
PULSES OUTPUT
IMP: 30s Sr 10:10:00
PULSES OUTPUT
ACTIVATION: NO
IMP: 30s Sr 10:10:00
PULSES OUTPUT
ACTIVATION: NO
TIME TO AJUST
IMP: 30s Sr 10:10:00
49