Installing The Anti-Tip Bracket; Installation; Installation Methods; Anti-Tip Bracket Installation - Vintec A18342801 Guide D'utilisation Et D'entretien

Installing the Anti-Tip
Bracket
CAUTION
If your Wine Cabinet is not located
under a counter top (free standing), you
must use an anti-tip bracket installed
as per these instructions. If the Wine
Cabinet is removed from its location for
any reason, make sure that the bracket
is properly engaged when you push
the Wine Cabinet back into the original
location. If the bracket is not properly
engaged, there is a risk of the Wine
Cabinet tipping over, causing property
or personal injury if you or a child stand,
sit, or lean on an open shelf.
CAUTION
Any finished flooring should be
protected with appropriate material to
avoid damage when moving the unit.
Tools you will need:
Safety Stud
goggles finder
Hammer
Gloves
or Mallet
ALL UNITS CAN TIP
Screwdriver
Electric drill
with Wrench
3/8" drill bit

Installation

NOTE
While performing installation described
in this section, gloves, safety glasses, or
goggles should be worn.
WARNING
This appliance may tip when shelves
are extended, causing damage or
injury. If this appliance is used in a FREE
STANDING application, the anti-tip
bracket must be installed following these
instructions!
IMPORTANT
Determine the final location of the
appliance before attempting to install
the bracket. You will need to choose
one of the three installation methods
below.

Installation methods:

1. DRYWALL
2. WOOD FLOOR
3. CONCRETE FLOOR

Anti-tip bracket installation

The bracket can be installed at the left
bottom OR right bottom of the back of
the unit. You can choose which side is
convenient for you.
9