Installing The Anti-Tip Bracket; Installation - Vintec A17653101 Guide D'utilisation Et D'entretien

Installing the Anti-Tip
Bracket
CAUTION
You must use an anti-tip bracket
installed as per these instructions. If
the Wine Cabinet is removed from its
location for any reason, make sure that
the bracket is properly engaged when
you push the Wine Cabinet back into
the original location. If the bracket is
not properly engaged, there is a risk of
the Wine Cabinet tipping over, causing
property or personal injury if you or a
child stands, sits, or leans on an open
shelf.
CAUTION
Any finished flooring should be
protected with appropriate material to
avoid damage when moving the unit.
NOTE
While performing installation described
in this section, gloves AND safety
glasses, or goggles should be worn.
WARNING
This appliance may tip when shelves
are extended, causing damage or
injury. If this appliance is used in a FREE
STANDING application, the anti-tip
bracket must be installed following these
instructions!
ALL UNITS CAN TIP

Installation

IMPORTANT
Determine the final location of the
appliance before attempting to install
the bracket.
It is recommended to install the ant-tip
device to avoid the unit from tipping over.
The anti-tip device must be fixed/screwed
to the wall allowing the wine cabinet to be
pushed into position.
1. Choose the installation location.
2. Place the bracket on the floor
against the wall and use 2 wood
screws (not provided) (size D6 with
minimum length of 20 mm) to secure
the bracket to the wall. Ensure at
least one screw is secured into a
stud.
9