Child Lock; Sabbath Mode - Vintec A17653101 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Lights Behavior
Lights Dim Level
Bottom temperature display shows the
light setting code.
Press ∨ / ∧ to change the Dim Level.
1L: Lowest level / least bright (default)
2L:...
3L: Highest level / most bright

Child Lock

Press and hold Mode button
for 3 seconds to activate/
deactivate child lock.
seconds to activate/deactivate Sabbath
mode.
When activated, Lower and Upper
temperature displays show "Sb" and "On"
or "Sb" until deactivated. In this state:
Any button command is
disabled apart from the increase
top temperature set and
decrease bottom temperature
set combination command to
deactivate the Sabbath mode.
All lights are turned Off - apart from
"Sb" and "On".
All sounds are muted except
the audio alarm from High/Low
Temperature alerts.
Opening or closing the door will
not turn on or off any lights, digital
readouts, solenoids, fans, valves,
compressor, icons, tones, or alarms.
Controls and Settings
Temperature
display shows
the light setting
code:
Child lock
indicator
prevents
changes to the
UI until disabled.
Sabbath
Mode
Simultaneously
press and hold
the increase
and decrease
buttons for 5
Alerts will not be displayed until
the Sabbath Mode is deactivated,
except by the High/Low
Temperature alerts.
Sabbath Mode exception:
The High/Low Temperature alerts will
be displayed in case of high or low
temperature inside the appliance. The
alert icon turns On, but will not blink, and
it will remain until the Sabbath Mode is
deactivated. An audio alarm will sound and
automatically turn off after 10 minutes.
When Sabbath Mode is deactivated,
temperature displays will show the current
temperatures.
°C/°F set
Simultaneously press and hold the
increase lower temperature set and light
buttons for 5 seconds to toggle the
temperature units between °F and °C.
Reset Filter Alert
After 6 months, the filter
alert icon turns On.
Simultaneously press
and hold the Mode and
decrease buttons for 5
seconds to reset the filter change alert.
After reset, the icon turns Off and the
count is reset.
13

Publicité

Table des Matières
loading

Table des Matières