Vintec A18342801 Guide D'utilisation Et D'entretien page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
8
Installation of Your Wine
Cabinet
Your Vintec Wine Cabinet has been
designed for either free-standing or under
counter installation. When under counter,
your unit does not require additional air
space for top, sides or rear. In either case,
the front grille must NOT be obstructed.
This appliance is designed to be for
free standing installation or under
counter (fully recessed). (Refer to
sticker located on the back of this
appliance.)
This appliance is intended to be used
exclusively for the storage of wine.
Place your Wine Cabinet on a floor
that is strong enough to support it
when it is fully loaded. To level your
Wine Cabinet, adjust the front leveling
legs
at the bottom of the unit.
This appliance uses flammable
refrigerant. So never damage
the cooling pipe work during the
transportation.
Locate the Wine Cabinet away from
direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating
and heat sources may increase
electrical consumption. Extreme cold
ambient temperatures may also cause
the unit not to perform properly.
Avoid locating the unit in moist areas.
Plug the Wine Cabinet into an
exclusive, properly installed, grounded
wall outlet. Do not under any
circumstances cut or remove the third
(ground) prong from the power cord.
Any questions concerning power
and/or grounding should be directed
toward a certified electrician or an
Authorized Products Service Center.
NOTE
To ease unit installation and removal, it
is recommended that the cabinet rough
opening dimensions be increased by at
least ¼ inch over the dimensions given
for your unit.
NOTE
All units require zero clearance when
installed flush with a cabinet or wall.
Before Using Your Wine Cabinet
Remove the exterior and interior
packing.
Before connecting the Wine Cabinet to
the power source, let it stand upright
for approximately 2 hours. This will
reduce the possibility of a malfunction
in the cooling system from handling
during transportation.
Clean the interior surface with
lukewarm water using a soft cloth.
Using your Wine Cabinet
Store wine in sealed bottles.
Do not overload the cabinet.
Do not open the door unless
necessary.
Do not cover shelves with aluminum
foil or any other shelf material which
may prevent air circulation.

Publicité

Table des Matières
loading

Produits Connexes pour Vintec A18342801

Table des Matières