Vintec A18342801 Guide D'utilisation Et D'entretien page 10

10 Installation
DRYWALL installation:
A
1
1. After you have chosen the installation
location, place the bracket on the floor
with (1) against the wall, use Screw
(E) (2 pcs) to secure the bracket to
the wall. Ensure at least one screw is
secured into a stud.
2. Align lower corner of unit and bracket
slot (A), secure with hexagon bolt (B),
lock washer (C) and flat washer (D).
IMPORTANT
The screws MUST enter into a wood
stud. If the wall contains metal studs
or similar materials, then the floor
installation must be used.
Hexagon Bolt
B
1/4" x 1.2" (1 pc)
Lock Washer (1 pc)
C
D
Flat Washer (1 pc)
Screw
E
ST4x35 (2 pcs)
A
D
C
B
Wall stud
WOOD FLOOR installation:
A
2
1. After you have chosen the installation
location, place the bracket on the
wood floor. Use Screw (E) (2 pcs) to
secure bracket to floor using bracket
holes (2).
2. Align lower corner of unit and bracket
slot (A), secure with hexagon bolt (B),
lock washer (C) and flat washer (D).
E
Hexagon Bolt
B
1/4" x 1.2" (1 pc)
Lock Washer (1 pc)
C
D Flat Washer (1 pc)
Screw
E
ST4x35 (2 pcs)
A
D
C
B
E