Sabbath Mode - Vintec A18342801 Guide D'utilisation Et D'entretien

16 Controls and Settings

Sabbath Mode

Simultaneously press and hold the
increase and decrease buttons for 5
seconds to activate/deactivate Sabbath
mode.
deactivated. In this state:
• Any button command is disabled apart
from the increase top temperature set
and decrease bottom temperature set
combination command to deactivate
the Sabbath mode.
• All lights are turned Off - apart from "Sb".
• All sounds are muted except the audio
alarm from High/Low Temperature
alerts.
• Opening or closing the door will not turn
on or off any lights, digital readouts,
solenoids, fans, valves, compressor,
icons, tones, or alarms.
• Alerts will not be displayed until the
Sabbath Mode is deactivated, except
by the High/Low Temperature alerts.
but will not blink, and it will remain until the
Sabbath Mode is deactivated. An audio
alarm will sound and automatically turn off
after 10 minutes.
When activated,
Lower and Upper
temperature
displays show
"Sb" until
Exception:
The High/Low
Temperature alerts
will be displayed in
case of high or low
temperature inside
the appliance. The
alert icon turns On,
When deactivated,
temperature display
shows the current
temperature.
°C/°F set
Simultaneously press
and hold the increase
lower temperature set
and light buttons for 5 seconds to toggle
the temperature units °F and °C.
Reset Filter alert
Simultaneously press
and hold the Mode
and decrease buttons
for 5 seconds to reset the filter change
count.
If the alert is on, it turns off.
Change filter alert
After 6 months, the filter alert icon turns
On.
After reset, the icon turns Off and the
count is reset.
Set Cellaring
Press to toggle from Single to
Cellaring Mode
NOTE
Cellar mode temperature is the
recommended temperature for longer
term storage of wine (54°F/12°C).
Single Zone
the Mode button, the "CE" stops blinking
and shows "CE" until the Cellaring mode
is deactivated. When deactivated, the
previous temperature is shown.
In Cellaring mode, the temperature is fixed
and cannot be changed from 54ºF/12ºC.
If the mode is
set to Cellaring,
the temperature
display shows "CE"
blinking. After 5
seconds without
any interaction with