Maintenance; Accessories - RIDGID R45171 Manuel D'utilisation

MAINTENANCE

WARNING:
Before performing any maintenance, make sure
the tool is unplugged from the power supply and
the switch is in the off ( O ) position. Failure to
heed this warning could result in serious personal
injury.
WARNING:
Always wear safety goggles or safety glasses
with side shields during power tool operation
or when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts may create a hazard
or cause product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
 Periodically check all clamps, nuts, bolts, and screws for
tightness and condition. Make sure the throat plate is in
good condition and in position.
 Check the blade guard assembly for proper installation,
fit, and clearances, and for free movement.

ACCESSORIES

Look for these accessories where you purchased this product or call 1-866-539-1710:
 Dado Throat Plate ....................................................................................................................................... 089037006914
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
 To maintain the table surfaces, fence, and rails, periodi-
cally apply paste wax to them and buff to provide smooth
functioning. To prevent work from slipping during cutting
operation, do not wax the working face of the miter gauge.
 Protect the blade by cleaning out sawdust from underneath
the table and in the blade teeth. Use a resin solvent on
the blade teeth.
 Remove the screws and open the blade cover. Clean
sawdust and wood chips from the blade cover. Close
and secure. (See figure 55.)
 Clean plastic parts only with a soft damp cloth. Do
not use any aerosol or petroleum solvents.
LUBRICATION
This saw's motor bearings have been packed at the factory
with proper lubrication.
 Clean screw threads and nuts with a solvent recommended
for gum and pitch removal.
 Lubricate screw threads, nuts, and bearing points (includ-
ing those on the blade guard assembly and miter gauge).
39 − English
BLADE
COVER
SCREWS
SCREW
Fig. 55