Hama Touch Mode D'emploi page 5

6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and
performs initial setup.
ote
N
• Initial setup takes approx. 2 minutes.
• During connection, the wireless symbol on the measuring
station will ash (4).
• Do not press any buttons during setup. Otherwise, values
may not be transmitted correctly and there is a risk of
value errors and inaccuracies.
• The setup process is completed when the indoor (7/8) and
outdoor (2/3) measurement data is displayed.
• The measured value is automatically updated by the base
device about every 45 seconds.
• If the temperature is outside of the measuring range,
--.- (lower than minimum temperature) or --.- (higher than
maximum temperature) will appear on the temperature
display.
• If the base station still does not receive a signal from the
measuring station, press and hold the 'CH | ' button
(12) for approx. 3 seconds to start the manual search for
the signal.
Display
Display ashing
Displayed continuously
Displayed continuously
ote – Faulty transfer of measured values
N
• In isolated cases, interference - e.g. from a WLAN
network, a computer or a television set - can cause the
transfer of measured values between the measuring
station and the base station to fail.
• In this case, you must resynchronise the stations by
brie y removing the batteries from both stations and
reinserting them.
• If the measured values are not transferred again once
the batteries are inserted, replace the batteries with
new ones.
• If necessary, select a new location for the base station in
order to avoid possible interference in the future.
4
Search for a signal from the
measuring station
Active
Successful –
signal is being received
Inactive –
no signal reception
6.2 Selecting the channel/other measuring stations
ote
N
• You can install two more measuring stations in addition to
the included measuring station. Ensure that the base and
measuring stations are set to the same channel.
• Press the 'CH | ' button (12) to set the channel to that
set on the respective measuring station. Channel 1, 2 or 3
is displayed
6.3Basic and manual settings
Automatic setting using the DCF signal
After the rst time the base station is switched on and
successful transmission is established between the base station
and the measuring station, the clock will automatically search
for a DCF signal. During the search, the wireless symbol (15)
will ash.
When the radio signal is received, the date and time are
automatically set.
Radio icon
No symbol
Radio icon
Flashing display
Constant display
No display
Signal strength
No reception
Poor
Excellent
Searching for the
DCF signal
Active
Successful – signal is being
received
Error – signal search ended