AEG SKS68840F0 Notice D'utilisation page 36

36
What to do if...
Problem
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
DEMO appears on the dis-
play
Warning signal
The warning signals of the control and signalling system of the appliance are displayed on
the Visual Display.
The system will give out a signal if:
• An error has occurred in the operation of
the appliance. In case the electronic system
of the appliance cannot identify the real
temperature a sign will appear on the tem-
perature display.
• Until the staff of the customer service arrive
at the spot and solve the problem, the appli-
ance will continue operating with the help
of a spare program.
Possible cause
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
The appliance is in demonstra-
tion mode. (dEMo)
Solution
Attach the melting water outlet
to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
Keep the OK button pressed for
approximately 10 second until a
long sound of buzzer is heard and
the display shuts off for a short
time; the appliance starts working
regularly