Cameo H1 D Manuel D'utilisation page 20

STATIC STANDALONE MODE
The standalone mode Static allows the Dimmer, Dimmer Fine and Strobe values to be set directly
on the device with values between 000 and 255, in a similar way to with a DMX controller. In this
way, an individual scene can be created without an additional DMX controller.
Select Stand Alone, confirm the selection, then select Static and confirm again. Now select the
menu item you wish to edit and confirm the selection. In the selected menu item, set the desired
value from 000 to 255 and confirm the entry. The strobe effect values correspond to those in
channel 3 of the DMX table 4 CH.
TIMER FUNCTION
The timer function allows the standalone mode Static to be timer controlled in such a way that the
Fade In time can be configured from 0.5 seconds to 24 minutes, the Dwell Time from 0.5 seconds
to 24 hours and infinite (Limitless) and the Fade Out time from 0.5 seconds to 24 hours. After
activation of the timer function, the timer control will be implemented upon the next system start.
Select Stand Alone, confirm the selection, then select Timer and confirm again. Under Switch,
select the setting On and confirm. For the individual timer control settings, select Fade In, Dwell
Time or Fade Out and confirm. You can now set the respective value as desired. Confirm all
entries. To deactivate the timer function, under point Switch, select the setting Off and confirm.
Please note: The timer function is suitable for use in master/slave mode via cable.
20