Bosch PLR 25 Notice Originale page 24

24 | English
To change the reference level, press the button (1) until the required reference level is
shown on the display. The rear edge of the measuring tool is pre-set as the reference
level every time the measuring tool is switched on.
Measuring functions
Measuring length
Select the length measurement function
Press the measuring button (4) once to aim at the target surface and
again to measure.
24.589 m
6.111 m The measured value will be shown at the bottom of the display.
8.121 m
Repeat the above-mentioned steps for each subsequent measurement.
25.000 m
The last four measured values are shown on the display. The last meas-
ured value is at the bottom of the display, the penultimate measured value is above it,
and so on.
Note: Press and hold the measuring button (4) to switch to the length measurement
function from any measuring function.
Area measurement
Select the area measurement function .
Then measure the width and length one after the other as with a length measurement.
The laser beam remains switched on between the two measurements. The distance to be
measured flashes in the indicator for area measurement .
The first measured value is shown at the top of the display.
After the second measurement has been completed, the area will be
24.589 m
automatically calculated and displayed. The end result is shown at the
24.589 m
bottom of the display, while the individual measured values are shown
604.62 m
2
above it.
Volume measurement
Select the volume measurement function
Then measure the width, length and height one after the other as with a length measure-
ment. The laser beam remains switched on between the three measurements. The dis-
tance to be measured flashes in the indicator for volume measurement
After the third measurement has been completed, the volume will be
automatically calculated and displayed. The end result is shown at the
24.589 m
bottom of the display, while the individual measured values are shown
24.589 m
24.589 m
above it.
14866.9 m
3
1 609 92A 4NV | (26.10.2018)
(see "Measuring process", page 23).
.
.
Bosch Power Tools