Bosch GAS 35 L AFC Professional Notice Originale page 21

OBJ_BUCH-1746-002.book Page 21 Tuesday, July 23, 2013 1:17 PM
Container
Wipe out the container 1 from time to time with a commercial-
ly available, non-scouring cleaning agent and allow to dry.
Level Sensors (see figure J)
Clean the level sensors 35 occasionally.
– Unlock the latches 11 and remove the vacuum lid 10.
– Clean the level sensors 35 with a soft cloth.
– Reattach the vacuum lid 10 again and lock the latches 11.
Storage and Transport (see figure K)
– Wind the mains cable around the cable holder 15.
– Insert the accessories into the holders provided: Vacuum
tubes 29 in holders 17, crevice nozzle 25 in holder 18,
floor nozzle 28 in holder 19.
Correction of Malfunctions
Problem
The vacuum turbine does not start.
Vacuum turbine switches off.
Vacuum turbine does not restart after emptying the container. – Switch vacuum cleaner off and wait 5 seconds; switch on again
Vacuuming power decreases.
Dust escapes during vacuuming
The automatic shut-off (wet vacuuming) does not respond. – Clean level indicators 35 as well as the space between the level
Automatic filter cleaning inoperative.
The automatic filter cleaning cannot be switched off.
The automatic filter cleaning cannot be switched off.
After-sales Service and Application Service
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the vacuum cleaner.
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch Power Tools
– Undue the elastic tie-downs of the vacuum-hose holders 5
and place the vacuum hose 21 around the vacuum cleaner
lid into the holders 5.
Reattach the elastic tie-downs.
– Mount the L-Boxx onto the retainers 9.
– To prevent back injuries, remove a full disposal bag or dust
bag, or drain vacuumed-up fluids before transporting the
vacuum cleaner.
Carry the vacuum cleaner only by the carrying handle 8.
– Store the vacuum cleaner in a dry room and secure it
against unauthorised use.
– To lock the castors 14, actuate the castor brakes 13 by
pushing down.
Corrective Measure
– Check mains cable, mains plug, fuse, socket outlet and filling-
level sensors 35.
Mode selector switch 6 set to "Start/Stop automatic".
– Set mode selector switch 6 to the "vacuum" symbol and switch
the power tool connected to the socket outlet 4 on.
– Empty container 1.
after 5 seconds.
– Clean level indicators 35 as well as the space between the level
indicators 35 with a brush.
– Remove clogs from vacuum nozzle, vacuum tubes 29, vacuum
hose 21 or flat-fold filter 24.
– Replace disposal bag 23 or dust bag.
– Engage filter cover 34 properly.
– Mount vacuum cleaner lid 10 properly and lock latches 11.
– Replace flat-fold filter 24.
– Check proper installation of the flat-fold filter 24.
– Replace flat-fold filter 24.
indicators 35 with a brush.
The automatic shut-off does not function with non-conductive
liquids or foam/bubbles.
– Monitor the level continuously.
– Activate the filter cleaning (actuate the AFC button 3).
– Connect the vacuum hose 21.
– Contact an authorised service agent for Bosch power tools.
– Contact an authorised service agent for Bosch power tools.
Bosch's application service team will gladly answer questions
concerning our products and their accessories.
English | 21
1 609 92A 0D1 | (23.7.13)