Installation And Connection; Operating - Bartscher 103.063 Mode D'emploi

•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface.
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Never install the device in a damp or wet environment.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
unit directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

•
Prior to first use, wash the unit (see 6.2 „Cleaning").
•
Prepare appropriately-sized plates (Ø max. 320 mm). Prior to placing plates inside
the unit, they should be washed and dried. Place plates on the appropriate shelves.
NOTE!
For best heating of plates, the shelves should be filled.
- 22 -