Microwave Oven Control; Display; Number Codes; Start - Whirlpool YMH1141XM Guide D'utilisation Et D'entretien

Display

When power is first supplied to the microwave oven, a ":" will
blink on the display. Touch CANCEL•OFF to stop the blinking.
If the ":" blinks on the display at any other time, a power failure
has occurred. Touch CANCEL•OFF and reset the clock if needed.
If "RETRY" blinks on the display for 1 second, an invalid value
has been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.
6

MICROWAVE OVEN CONTROL

Number Codes

The microwave oven is preset with shortcut number codes. A
number code includes one or more of the following: cooking
power, cook time and food quantity or weight. See the charts in
the "Cooking" and/or "Reheating" sections for additional
information.
The START pad begins any function. If not touched within
5 seconds after touching a pad, "START?" will appear on the
display as a reminder. If not touched within 1 minute after
touching a pad, the display will return to the time of day mode
and the programmed function will be canceled.
If cooking is interrupted, touching START will resume the preset
cycle.
Cancel•Off
The CANCEL•OFF pad stops most functions except for the
Timer, Child Lock and Demo Mode.
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle.

Add Minute

Cook time may be added in 1-minute increments, up to
99 minutes, by touching ADD MINUTE.
Touching ADD MINUTE during a cook cycle will add 1 minute of
cook time at the current cook power.
Touching ADD MINUTE when the microwave oven is not in use,
or after a cook cycle has ended, will start the microwave oven for
1 minute of cook time at 100% cook power.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear and ":" will appear on the display.

Start

Clock