Junker+ JH33AC 1 Série Notice D'utilisation page 61

Removing the intermediate panel
Lift the intermediate panel slightly and pull it out towards you.
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting the intermediate panel
Note: During installation, make sure that the lettering "top right"
is upside down at the bottom left.
Insert the intermediate panel towards the back as far as it will
go.
Fitting the door panel
Insert the door panel at an angle towards the back into both
1.
brackets as far as it will go. The smooth surface must face
outwards.
Put the cover back in place and press on it until it clicks in
2.
place.
Refit the appliance door.
3.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side (figure A).
Pull the hook-in rack forwards at the rear and unhook to the
2.
side (figure B).
Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the indentation (a) facing
4.
downwards, so that the shelf heights match.
Insert the hook-in rack at the rear as far as it will go and push
5.
to the rear (figure C).
Insert the hook-in rack at the front as far as it will go and push
6.
downwards (figure D).
61