Installation Flow Sensor (Fs); Installation Of The Ball Valve - Zenner C5-CMF Notice D'installation Et D'utilisation

With combined heat and cooling
measuring or only cooling measuring
the calculator has to be mounted on
the wall for protection of external
condensation (for Germany and
Austria: in the case of cooling and
combined heat / cooling meters, the
cooling registers are not calibrated
and may not be used for billing pur-
poses in commercial transactions.
For this purpose, devices with a
separate type-examination certificate
are currently required).
The revision of the approval can be
identified clearly in the display menu
(Level 3). The measuring capsule
flow sensor CMF is only allowed to be
used with the connection interface
according to DIN EN 14154-2 respec-
tively DIN EN ISO 4064-4 which are
specified in the technical data. The
use of transition pieces or adapters
inserts is not permitted.

Installation flow sensor (FS)

Mount ball valves up- and down-
■
stream of the flow sensor.
Consider the correct installa-
■
tion point. Normally this is the
return (the colder pipe in heating
systems). Note the type plate
information.
Consider the correct flow direc-
■
tion. This is indicated by an arrow
on the side of the the connection
interface.
H2=25 mm
H2=25mm
Combi version type IST, TE1,
M60, PCC
At type A1, the arrow is at the bot-
■
tom of the measuring capsule.
The use of flow direction convert-
■
ers is not permitted!
Install horizontally or vertically
■
only, not tilted, inclined or over-
head. Installation into horizontal
or upstreaming or downstreaming
pipelines.
Do not install at highest point of
■
piping to avoid air inside the flow
sensor.
Consider the dimensions of
■
the heat meter. Axial distance
between two flow sensors at least
135 mm.

Installation of the ball valve

Mount ball valves up- and down-
■
stream of the flow sensor.
Mount a ball valve with bore
■
M10x1 for direct sensors in the
supply. This is required for the in-
stallation of the supply sensor (for
type A1 a special ball valve with
temperature sensor connection
is required with external thread
M12x1,5.)
For symmetrical temperature sen-
■
sor installation, mount an identi-
cal ball valve in the return. This is
required for the installation of the
supply sensor.
H2=25mm H2=25 mm
Combi version type ASF A1
61 53
H2=25 mm
Combi version type A1
H2=25mm
19