Velleman DVM821 Mode D'emploi page 9

Use extreme caution when measuring voltages higher than 60 VDC
or 30 VAC rms.
Always place your fingers behind the protective edges of the test
probes while measuring!
10.1 DC VOLTAGE MEASUREMENT
1. Set the rotary switch in the desired V
measured is unknown beforehand, you should set the range switch in
the highest range position and then reduce gradually until the ideal
resolution is obtained.
2. Connect the test leads to the source being measured.
3. Read the voltage value on the LCD display along with the polarity of
the red lead connection.
10.2 AC VOLTAGE MEASUREMENT
1. Set the rotary switch in the appropriate V~ position.
2. Connect the test leads to the source to be measured.
3. Read the voltage value on the LCD display.
11. Current Measurement
Do not measure circuits that may contain voltages > 500 V
Use extreme caution when measuring voltages higher than 60 VDC
or 30 VAC rms.
Always place your fingers behind the protective edges of the test
probes while measuring!
1. Set the rotary switch (DCA) in the desired position.
2. Open the circuit in which the current is to be measured and connect
the test leads to the circuit IN SERIES.
3. Read the current value and the polarity of the red lead connection on
the LCD display.
12. Resistance Measurement
Do not conduct resistance measurements on live circuits. Make sure
all capacitors in the circuit are depleted.
1. Set the rotary switch in the appropriate "" range position.
2. Connect the test leads to the resistor to be measured and read the
LCD display.
V. 02 – 04/03/2016
DVM821
position. If the voltage to be
9 ©Velleman nv