EINHELL TC-PE 150 Instructions D'origine page 16

Warning!
For health safety reasons it is imperative that you
use a dust container or a dust extraction system.
5.3 Fitting/removing the sanding/grinding
plate (Fig. 5)
•
Place the open-ended wrench (7) between
the sanding/grinding plate (6) and the
housing.
•
Undo the sanding/grinding plate by turning.
•
Fit a new sanding/grinding plate in reverse
order.
•
Remove the open-ended wrench.
•
Check that the sanding/grinding plate is secu-
re.
5.4 Fastening the abrasive paper
The Hook-and-loop fastener enables easy chan-
ging of the abrasive paper. Make sure that the
vacuum extraction holes on the abrasive paper
and the sanding disk are aligned.
6. Operation
6.1 Connecting to a compressed air supply
•
Connect the nipple (5) to the quick-lock coup-
ling of a compressed air hose (the hose is not
supplied).
•
Note the maximum permissible operating
pressure of the equipment.
6.2 Switching On/Off (Fig. 1)
Switching on: Depress the operating switch (2)
Switching off : Let go of the operating switch (2)
6.3 Setting the speed (Fig. 1)
The equipment speed can be controlled:
•
The control level (3) points towards the ext-
ractor adapter (1): Maximum speed
•
The control lever points away from the extrac-
tor adapter: Reduced speed
•
Check the speed setting before carrying out
any work on the workpiece.
6.4 Working with the eccentric sander/grinder
Warning! The workpiece you want to sand/grind
must never be held in your hand. Secure the
workpiece on a sturdy surface or with a vise.
Place the whole surface area of the sanding disk
on the material.
•
Switch on the machine and move it with gent-
le pressure over the workpiece, making circu-
Anl_TC_PE_150_SPK9.indb 16 Anl_TC_PE_150_SPK9.indb 16
GB
lar or transverse and linear movements.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
best grit size for the job by carrying out san-
ding tests.
Danger!
The dusts which are formed while the equipment
is being used may be a health hazard:
•
Always wear safety goggles and a dust mask
during sanding work.
•
All persons who work with the equipment or
enter the workplace must wear a protective
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Paints containing lead are not allowed to be
used!
7. Cleaning, maintenance and
ordering of spare parts
Disconnect the compressed air supply from the
equipment before performing any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment im-
mediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment.
7.2 Maintenance
Warning!
Disconnect the equipment from the compressed
air supply before you carry out any maintenance
or cleaning work.
Compliance with the maintenance instructions lis-
ted here will help this quality product provide you
with a long service life and trouble-free operation.
Regular lubrication is essential for your equip-
ment to work properly for a prolonged period of
time.
- 16 -
19.06.2019 11:15:13 19.06.2019 11:15:13