EINHELL BT-AC 180 Kit Instructions De Service page 11

Anleitung_BT-AC_180_Kit_SPK1:_
4. Technical data
Power supply:
Motor rating in kW/HP:
Operating mode
Compressor speed in rpm:
Operating pressure in bar:
Theoretical intake rate in l/min.:
Sound power level L in dB:
WA
Sound pressure level L in dB:
pA
Protection type:
Machine weight in kg:
Operating mode S3 - 15% - 10min: S3 = Intermittent
mode without influencing the starting process. This
means that during a period of 10 min the max.
operating time is 15% (1.5 min).
5. Points to note when setting up the
compressor
Examine the machine for signs of transit
damage. Report any damage immediately to the
company which delivered the compressor.
The compressor should be set up near the
working consumer.
Avoid long air lines and long supply lines
(extensions).
Make sure the intake air is dry and dust-free.
Do not set up the compressor in damp or wet
rooms.
The compressor may only be used in suitable
rooms (with good ventilation and an ambient
temperature from +5°C to +40°C). There must be
no dust, acids, vapors, explosive gases or
inflammable gases in the room.
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor in
areas where work is conducted with sprayed
water.
26.08.2008 9:24 Uhr
6. Assembly and starting
Important!
220-240 V ~ 50 Hz You must fully assemble the appliance before
using it for the first time.
1.1/1,5
S3 15% 10 min
6.1 Voltage
3450 The compressor is equipped with a mains cable with
shock-proof plug. This can be connected to any
8
230V ~ 50Hz shock-proof socket which is protected
180
by a 16 A fuse. Before you use the machine, make
sure that the mains voltage complies with the
94.7
specifications on the rating plate. Long supply
74.5
cables, extensions, cable reels etc. cause a drop in
IP 20
voltage and can impede motor start-up. In the case
of low temperatures below +5°C, motor start-up is
6,5
jeopardized as a result of stiffness.
6.2 On/Off switch (4)
To switch on the equipment set the On/Off switch (4)
to position 1.
Move the On/Off switch (4) to position 0 to switch off
the equipment.
6.3 Compressed air hose with quick-lock
coupling (3)
Connecting:
Insert the nipple of the air tool into the quick-lock
coupling, the sleeve will spring forward automatically.
Disconnecting:
Pull back the sleeve and remove the tool. Important.
When releasing the quick-lock coupling, be sure
to hold the coupling piece to protect yourself
against injury from the rebounding hose.
6.4 Tire pressure gauge with adapters
(Fig. 2/Item 6)
Working pressure in bar: 0 – 8
Range of applications:
The tire pressure gauge allows you to inflate tires
easily and exactly. Use the pressure gauge to check
the tire pressure. If the tire pressure is too high, you
can reduce the pressure with the integrated relief
valve (e).
The tire pressure gauge comes with a valve adapter
for car tire valves. Other valve types can be filled
using the supplied adapters (a - c).
Using the equipment as a blow-out pistol (Fig. 3)
To use the tire pressure gauge as a blow-out pistol
you must first unscrew and remove the hose with the
Seite 11
GB
11