Gloria MULTIBRUSH li-on Mode D'emploi page 31

Another factor is overly frequent starting
and stopping during cleaning, which can
also reduce battery operating time.
Handle battery and device as described
in the instructions.
7.1.3 Assembly of the brushing
tools
Figures 11 - 19
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or com-
ponents can still be very hot and may
cause burns.
It is therefore important to observe
the following safety instructions:
Wear protective gloves during
assembly!
Disassembly of surface brush followed by
assembly of the joint brush
Switch off the device and remove the
battery (C).
Open the locking device (K)
11
the guide arm (M), as shown in the
illustration.
With the lock applied (K) remove the
12
guide arm (M) and then the surface
brush (N).
Now open the locking device (K)
13
of the drive arm (P), as shown in the
illustration and remove, with the lock
applied, (K) the drive arm (P) with
safety guard (O).
The surface brush is now successfully
dismantled.
Put the guiding wheel (I), as shown in
14
the illustration, on the steering side of
the motor/gear unit (L). Now slide the
lock (K) into open position
this and press the guiding wheel (I)
further onto the coupling shaft up to
the stop.
Release the spring-loaded locking
device (K). The guiding wheel (I) is
locked when the locking device
independently returns to its original
position
Put the pre-assembled joint brush
15
unit, as illustrated, on the drive side of
the motor/gear unit (L). Slide the lock
(K) into open position
and press the joint brush unit further
into the drive shaft up to the stop.
Release the spring-loaded locking
device (K), the joint brush unit is
locked when the locking device
independently returns to its original
posi tion
Disassembly of joint brush followed
by assembly of the surface brush
of
Dismantle the joint brush according to
handling and function described above.
Open the locking device (K)
16
drive arm (P) and, with the lock
applied, (K) put the drive arm (P) with
safety guard (O), onto the drive side of
the motor/gear unit (L), as illustrated.
Release the spring-loaded lock (K),
the drive arm is locked when the
locking device independently returns
to its original position
31
, hold
.
, hold this
.
of the
.