Commissioning; Operation - Gloria MULTIBRUSH li-on Mode D'emploi

7

Commissioning

ATTENTION!
DEVICE PROTECTION!
max. 45 °C
WARNING! BEFORE COMMISION-
ING OBSERVE CHAPTER 2 "FOR
YOUR SAFETY".
You should therefore observe the
following safety instructions:
Clean the roller/joint brush (N/J)
before each cleaning operation.
The air inlet openings on the
motor/gear unit (L) must not be
blocked or covered.
Check on a small, if possible hidden
area, that the ground to be cleaned
will not be damaged by the brush-
ing action.
Never use the device too long on
one spot, always guide at walking
pace.

7.1 Operation

Figures 7 - 10
Insert the charged battery into the bat-
7
tery adapter as shown until this engages
with a noticeable 'click'.
Always place the device parallel on
8
the ground which is to be cleaned.
Identify the most comfortable but also
most effective working angle for your-
self and then adjust the 5 click-stop
safety guard (O) so that the rubber lip
is just above the ground.
Make sure that the surface to be
cleaned is free from debris e.g. stones,
screws etc., which could be flung up.
CAUTION! RISK OF INJURY FROM
ROTATING BRUSHING TOOL!
Never start the device in a tilted
position!
Do not start or operate device if
bystanders are in the danger zone.
Never put your hands or feet near to
the rotating brushing equipment!
Never clean if others, in particular
children or animals, are in the area!
Never use the device in the rain.
You can regulate the speed of the
9
brush by pressing the speed control
on the adjustment wheel (R).
Speed recommendations for
GLORIA brushes
Position 1-2 soft brushes (wood brush)
Position 3-4 harder brushes (stone brush)
Position 5-6 joint brush (wire brush)
Hold the device securely by the
10
handle (A) and additional handle (E)
and switch on the device by pressing
and holding the ON/OFF safety
switch (D) in handle (A).
In case of work interruptions or
danger, release the ON/OFF safety
switch (D) immediately.
7.1.1 Battery status indicator
The battery is equipped with a status
indicator that is located on the handle
(A) and displays the charging status of
the battery. After the device is switched
on, the indicators are lit up for approx. 5
seconds.
Battery power (green LEDs):
Reserve ≤ 30%
7.1.2 Battery operating time
The service life of the battery mainly
depends on the load applied to the devi-
ce. Any cleaning work performed by app-
lying the brush with high pressure on the
surface to be cleaned will shorten the
service life of the battery.
30
≤ 60% 100%