Cleaning, Maintenance And Ordering Spare Parts; Disposal And Recycling; Storage - EINHELL TE-VC 36/30 Li S Traduction Du Mode D'emploi D'origine

7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend cleaning the equipment
immediately each time after use.
7.2 Cleaning the fi lter (Fig. 1/Item 3)
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment.
7.3 Cleaning the tank (Fig. 1/Item 7)
The tank can be cleaned with a damp cloth
and some soft soap or under running water,
depending on the amount of dirt.
7.4 Cleaning the fi lters
Cleaning the pleated fi lter (Fig. 2)
Clean the pleated fi lter (18) regularly by carefully
patting it and cleaning it with a fi ne brush or hand
brush.
Cleaning the foam fi lter (Fig. 2)
Clean the foam fi lter (15) with a little soft soap
under running water and allow it to air-dry.
Cleaning the fi lter (Figs. 19/20)
The fi lter (33) should be checked at regular
intervals and cleaned if necessary.
1. Remove the fi lter cover (34) (Fig. 19).
2. Take out the fi lter (33) (Fig. 20)
3. Clean the fi lter by tapping it or blowing it out.
4. Assemble in reverse order
7.5 Maintenance
At regular intervals and before each use, check
that the fi lters in the wet/dry vacuum are securely
fi tted.
Anl_TE_VC_36_30_Li_S_USA_SPK7.indb 12 Anl_TE_VC_36_30_Li_S_USA_SPK7.indb 12
EN
7.6 Ordering replacement parts:
Service
1. If your power tool requires service,
contact an authorized Einhell USA dealer
or call the Einhell USA customer service
center at 1-866-EINHELL
(1-866-346-4355). Only identical
replacement parts should be utilized for
repairs. This will ensure that the safety of the
power tool is maintained.
2. If the battery charger cable is damaged, it
must be immediately replaced to avoid a
hazard. Contact the Einhell USA
service center at 1-866-EINHELL
(1-866-346-4355) for assistance.

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.

9. Storage

Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation and
papers accompanying the products is strictly
subject to the express consent of iSC GmbH.
Subject to technical changes
- 12 -
customer
®
08.05.2019 10:28:16 08.05.2019 10:28:16