Cleaning, Maintenance And Ordering Spare Parts - EINHELL TE-VC 18/10 Li Traduction Du Mode D'emploi D'origine

6.3 Wet vacuuming
For wet-vacuuming, use the foam fi lter (14) (see
point 5.2).
Check that the fi lter is securely seated at all times.
When wet-vacuuming, the fl oating safety switch
(Fig. 3/Item 5) closes when the maximum tank
level is reached. At the same time, the suction
noise of the equipment will change and become
louder.
You must then switch off the equipment and
empty the tank.
Danger!
The wet/dry vacuum is not suitable for the
vacuuming of combustible liquids. For wet
vacuuming, use only the supplied foam fi lter.
6.4 Blowing
Connect the suction hose (10) to the blow
connector (9) on the wet/dry vacuum.
6.5 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.6 Battery capacity indicator (Fig. 3 / item 2)
Press the battery capacity indicator switch (a).
The battery capacity indicator (2) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
Anl_TE_VC_18_10_Li_USA_SPK7.indb 10 Anl_TE_VC_18_10_Li_USA_SPK7.indb 10
EN
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend cleaning the equipment
immediately each time after use.
7.2 Cleaning the fi lter (Fig. 1/Item 3)
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment.
7.3 Cleaning the tank (Fig. 1/Item 7)
The tank can be cleaned with a damp cloth
and some soft soap or under running water,
depending on the amount of dirt.
7.4 Cleaning the fi lters
Cleaning the foam fi lter and the additional
fi lter (Fig. 2)
Clean the foam fi lter (14) and the additional fi lter
(16) with a little soft soap under running water and
allow them to air-dry.
7.5 Maintenance
At regular intervals and before each use, check
that the fi lters in the wet/dry vacuum are securely
fi tted.
7.6 Ordering replacement parts:
Service
1. If your power tool requires service,
contact an authorized Einhell USA dealer
or call the Einhell USA customer service
center at 1-866-EINHELL
(1-866-346-4355). Only identical
replacement parts should be utilized for
repairs. This will ensure that the safety of the
power tool is maintained.
2. If the battery charger cable is damaged, it
must be immediately replaced to avoid a
hazard. Contact the Einhell USA
service center at 1-866-EINHELL
(1-866-346-4355) for assistance.
- 10 -
customer
®
19.03.2020 10:55:08 19.03.2020 10:55:08