Sony MDS-JA30ES Mode D'emploi page 35

Labeling tracks and MDs with the remote
Z
OPEN/CLOSE
6
EDIT/NO
DISPLAY SCROLL TIME
PLAY MODE
CONTINUE SHUFFLE PROGRAM
A B C
1 2 3
F G H
6 7 8
K L M
11 12 13
P Q R
16 17 18
U V W
21 22 23
Z –
REPEAT A˜B
>
/ 25 ? !
WRITE
NAME
NAME CHAR NUM
·
CHAR
= +
0/)
0 )
CD-SYNC
STOP START STANDBY
CD PLAYER
P = +
1
Press NAME repeatedly until a flashing cursor
appears in the display, then do the following:
To label Make sure that the deck is
A track Playing, pausing, recording the
track to be labeled, or stopped after
locating the track to be labeled
An MD Stopped with no track number
appearing in the display
2
Select the character type as follows:
To select Press
Uppercase letters CHAR repeatedly until "Selected
AB" appears in the display
Lowercase letters CHAR repeatedly until "Selected
ab" appears in the display
Numbers NUM repeatedly until "Selected
12" appears in the display
3
Press an alphabet/number button to enter a
character.
After you enter a character, the cursor shifts
rightward and waits for the input of the next
character.
You can change the character type at any time
during Step 3 (see Step 2).
4
Repeat Step 3 until you have entered the entire
title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing.
Press CLEAR to erase the incorrect character, then
enter the correct one.
POWER
YES
EDIT/NO
D.O BIT FILTER
DATE
RECORDED PRESENT
D E
4 5
I J
9 10
N O
Alphabet/number
14 15
S T
buttons
19 20
X Y
24 25
. ,
A.SPACE M.SCAN
( )
CLEAR P. HOLD
CLEAR
p
P p
NUM
r
T.REC MUSIC SYNC
NO CLIP
FADE
DIGITAL REC LEVEL
Editing Recorded MDs
5
Press NAME again.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press p.
Changing an existing title Z
1
Press NAME, then do the following:
To change Make sure that the deck is
A track title Playing, pausing the track whose
title is to be changed, or stopped
after locating the track whose title
is to be changed
A disc name Stopped with no track number
appearing in the display
2
Hold down CLEAR or EDIT/NO until the current
title is erased.
3
Enter the new title.
Do Steps 5 to 8 of "Labeling Recordings" on page
34, or Steps 2 to 4 of "Labeling tracks and MDs
with the remote" on this page.
4
Press NAME.
Erasing a title on a disc (Name Erase)
Use this function to erase a title on a disc.
1
While the deck is stopped, playing, or pausing,
press EDIT/NO.
2
Turn AMS until "Name ?" appears in the display
and press AMS.
3
Turn AMS until "Nm Erase ?" appears in the
display and press AMS.
4
Turn AMS to select "Disc" to erase the disc title,
or the track whose title you want to erase and
press AMS.
"Complete!!" appears for a few seconds and the
title is erased.
To cancel Name Erase Function
Press p.
35 EN