Din Front/Rear-Mount; Din Front-Mount - Pioneer AVIC-N3 Manuel D'installation

DIN Front/Rear-mount

The display unit can be properly
installed either from "Front" (conven-
tional DIN Front-mount) or "Rear"
(DIN Rear-mount installation, using
threaded screw holes at the sides of the
unit chassis). For details, refer to the
following illustrated installation meth-
ods.
Before installing the display unit
• Remove the frame and the
holder.
To remove the frame, extend top and
bottom of the frame outwards in order
to unlock it.
Loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
• It becomes easy to remove the frame
if the front panel is released.
Holder
Screw (2 × 3 mm)

DIN Front-mount

Installation with the rubber bushing
1. Decide the position of the side
brackets.
When installing in a shallow space,
change the position of side brackets. In
this case, stick conceal tape on parts
that protrude from the dashboard.
Display unit
Frame
Side bracket
Flush surface screw (5 × 6 mm)
2. Install the display unit into the
dashboard.
After inserting the holder into the
dashboard, select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Dashboard
182
53
Holder
Display unit
Side bracket
Screw (2 × 3 mm)
• After installing the display unit into
the dashboard, reattach the frame.
• If you prefer an off-set installation
in which the front panel is pushed
further back, when there is a space
available at the back of the unit, use
AD-GA10 (sold separately).
Display unit
Conceal tape
Rubber bushing
Screw
24