Publicité
Les langues disponibles
Les langues disponibles
• The red and green light on the charger will glow for one second as a self-check,the
green light on charger will then flash to show that the battery pack is charging.
• If the red light comes on, it means the temperature of the battery pack is too
high, let it cool down before charging. If the red light flashes, the battery pack is
damaged and must be replaced.
• After approximately 1h, the green light will come on, indicating that the battery is
fully charged.
• Unplug the charger, and then remove the battery pack.
!
Never use a damaged battery pack.
WARNING
!
Always disconnect the charger from the power source when it is not in
use.
WARNING
NOTE: The battery pack and charger will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
NOTE: If you wish to charge two battery packs in succession, unplug the charger and
allow at least 15 minutes between charges.
b. Insertion and removal of rechargeable battery (Fig.2)
Fig.2
•
Lock the trigger switch on your tool by
setting the forward/reverse control in
the centre position.
•
To remove the battery pack from
the tool, firmly press and hold in the
battery pack release button and slide
the battery pack out of the tool.
•
To install the battery pack, align the
raised ribs on the battery pack with
the grooves inside the tool, slide the
battery pack fully onto the tool until
the battery pack "clicks" into position.
•
Make sure the release button on
the battery pack snaps in place and
battery pack is secured in the tool
before operating.
Publicité
