Fault Resolution; Cleaning The Pre-Filter; Cleaning The Fine Dust Filter Manually - Miele Blizzard CX1 Mode D'emploi

en

Fault resolution


Always disconnect the vacuum
cleaner from the power supply be-
fore attempting to rectify a fault.
Switch off at the wall socket and un-
plug it.
Cleaning the pre-filter (dia. 35 + 36)
The pre-filter is located at the rear of the
vacuum cleaner.
This should be cleaned when it is obvi-
ously dirty.
 Remove the dust container.
 Release the handle of the pre-filter
and remove the pre-filter.
 Rinse the pre-filter under running cold
water.

Do not use washing-up liquid!
Do not use any sharp or pointed ob-
jects!
Dry thoroughly after cleaning!
 Replace the dry filter in the dust con-
tainer and lock the handle.
 Replace the dust container in the va-
cuum cleaner.
Cleaning the fine dust filter
manually (dia. 37 - 42)
Allow a drying time of 24 hours.
 Remove the dust container.
 Release the fine dust container in the
direction of the arrow and remove it.
 Run a little water into the opening at
the top of the fine dust container.
 Gently shake the fine dust container
back and forth.
48
This will rinse out the dust.
 Shake to empty the water out.
 Release the top so that the marking is
pointing to the  symbol.
 Carefully lift the fine dust filter up-
wards and out of the fine dust con-
tainer.
 Rinse the outside of the fine dust filter
under running cold water.

Do not clean the inside of the
fine dust filter!
Do not use washing-up liquid!
Do not use any sharp or pointed ob-
jects and do not brush the fine dust
filter!
Leave the fine dust filter to dry for a
minimum of 24 hours after cleaning!
 Clean the fine dust filter container
with water and a little mild washing-
up liquid.
 Dry the fine dust filter container thor-
oughly.
 Insert the dry fine dust filter into the
dry fine dust container so that the
marking is pointing to the  symbol.
 Lock the top into place so that the
marking is pointing to the  symbol.
 Replace the fine dust container in the
vacuum cleaner and lock it into place.
 Replace the dust container in the va-
cuum cleaner.