Activating Automatic Send (Asend) - Seca 645 Mode D'emploi

Activating automatic
send (ASend)
11. Switch on the device, e.g. a wireless printer, you
want to integrate in the wireless group.
When the wireless printer is detected, you will hear
a beep.
NOTE
As soon as you have integrated a wireless prin-
ter in the wireless group, you then have to
select a print option (Menu\rF\APrt) and set the
time (Menu\rF\time).
12. Repeat step 11. for all the devices you want to
integrate in this wireless group.
13. Press the Enter key to stop the search procedure.
14. Press one of the arrow keys to have the devices
which have been detected displayed (in this case:
"MO 3" for a wireless printer).
If you have integrated several devices in one wire-
less group, press the arrow keys several times to
ensure that all devices have been detected by the
scale.
15. Exit the menu using the Enter key or wait until you
exit the menu automatically.
You can configure the device so that the measurement
results are automatically sent to all receivers which are
ready to receive and are registered to the same wire-
less group (e. g.: wireless printer, PC with USB wireless
adapter).
NOTE
If you are using a wireless printer, ensure that
"Off" is not set as the print option (see "Selec-
ting print option (APrt)" on page 102).
1. Switch on the device.
2. Select the "ASend" menu item from the "rF"
submenu and confirm your selection.
3. Select the "On" setting and confirm your selection.
You exit the menu automatically.
The seca 360° wireless network • 101
English